Detailing and modifications done to provide support to bear the weight of the Thunderjets are shown in the photos.
Several sizes of square brass tube were telescoped and mounted on a plastic tube to provide support for the weight of the Thunderjet models.
The tubing brass tubing mounted on the plastic tube was trapped between the B-29 fuselage halves.
The fuselage is assembled and shows the brass tubing and plastic tubing. The plastic tube also serves as the mounting point for the clear plastic tube that supports the model.
Brass tube passes through fuselage and is notched to brace on tab inside opposite wing.
Square brass tube is fitted inside wing to provide "mount" for tip coupling.
Coupling Detail Photo to Come.
Cockpit details shown along with battery pack to power the props which is hung on the travers tube.
A push-on/push-off switch is mounted in the rear ventral turret to switch the props on and off.
Dry fitting the wingtip coupling.
Rubber bands hold parts in place for dry fitting.
Most painting done, some decals applied.
Painted and decaled. Cockpit details and canopies on Thunderjets not completed.